QT-term-TCP for MacOSX

QT-term-TCP is a program which enables a workstation to connect to your local packet node via Telnet. The program scores in that it gives you a place to type, and a place for your received data. It's bonus feature is that it also gives you a window to watch diagnostic/monitor traffic from the node. You can watch messages pass through your node and see what visitors are doing.
The program makes it rather easy to make an outgoing connections through your node.
The only thing BPQ Term will not let you do is accept an incoming connection.

Here is a link to the MacOS version: qttermtcp-mac-2021-02-08.dmg 12.1MByte downloaded from the TARPN website.

Link to G8BPQ's page on QT-term-TCP

You'll have to do a little configuration. Run the program Go to the Setup menu and pull down to the TCP Hosts, and then click in the first entry. Fill in these figures:

IP address of your Raspberry PI
8011
local op callsign in lower case
p

The photos and examples in the QT-term-TCP page for Raspberry PI is pretty close to this version.
Check that out. QT-term-TCP